During play, you can adjust the bass level between BASS 1
(minhnum) and BASS 6 (maximum).
Using the system
Turn the SUPER WOOFER VOLUME +/-
control clockwise to increase the bass level
or turn it counterclockwise to decrease the
bass level,
|111| |mlZ| |111 |111| |11
| | | | |
|||| | | |||| |||| ||||
l,J I"I ,,,,i,,j i,,,i
Using the remote control
Press SUPER WOOFER VOLUME + to
increase the bass level or press SUPER
WOOFER VOLUME - to decrease it,
SUPER
WOOFER
VOLUME
@_'/ ................ .-
__ ...... p..
I". I...I ". '".
I,,,' I I ',,,' ',,,' ',,,'
"<
Note: This flmction is not effective when the headphones are in
use.
The Active Clear Sound (ACS) circuit emphasizes high-frequency
sound without lowering the signal-noise ratio, while adjusting its
output according to the input signal level. This results in a better
balance between the high-frequency sound and the low-frequency
heavy bass.
Press ACS (active clear sound) on the
system or on the remote control to turn it on
or off.
When it is turned on, tile ACS ON indicator lights in red.
t
CL[ARSOUNB _ I-ACSq
O O
or 11" _..
On system On remote control
• The ACS LEVEL indicator flashes in green according to the input
signal level.
Sound modes can be selected to enhance the type of music being
played.
Press SOUND to select the sound mode,
Each time you press the button, the sound mode changes as
fonows:
FL¢11111* BE¢11111*P0FIOCIi.I'-IqR
t !
SOUND
(_ SOUND
or
On system On remote control
Sound mode selection:
BEAT: Set to this position for music with a heavy beat, such as
rock and disco l;_msic.
POP: Set to this position for light music including popular and
vocal music.
CLEAR: Set to this position for crisp and clear sounding music
with transparent highs.
FLAT (no effect): Set to this position not to apply any sound
mode.
While the power is turned on, you can see the current time (clock)
at any time, as follows.
Using the remote control only
Press DISPLAY,
Each time you press the button, the display changes as follows:
CLOCK
r"I,,,I,! ,'....... ,',I,,,I,I
l" l ' l . l.' l ". l"l h..l I ' I I .' I.' I I.' I
I I I .h %.' '..'.'..' _ I II I .I..I.."..' %.'
MH_
Current sound source (e.g. FM103.5 MHz) -+ (clock) -+ (back to
the beginning)
Note: To let the clock work, you need to set the clock first. (See
"Setting the clock" on page 18.)
8
To Next Page
Loading...
Need help?
General
