65
Manufacturer codes for STBs
Examples:
For an Amstrad STB: Press [0], then [3].
For a Triax STB: Press [3], then [0].
When the manufacturer of your STB has 2 or more
codes, select the manufacturer codes in turn and find
the one that enables the STB and remote control to
operate properly.
6 Release [STB/VCR A].
NOTE
•Manufacturer codes are subject to change without
notice. You may not be able to operate the STB/
VCR produced by the manufacturer.
• After replacing the batteries of the remote control,
set the manufacturer code again.
Before the STB/VCR operation, select the remote
control mode for the STB/VCR.
1 Slide the remote control
mode selector to [STB/
VCR].
2 Press [STB] or [VCR].
•Operate the remote control by
pointing it at the STB/VCR.
Remote control button assigned for the STB
operation
Remote control button assigned for the VCR
operation
NOTE
• When the remote control mode selector is slid to
[STB/VCR], some buttons may not work.
Manufacturer
Code
Manufacturer
Code
JVC 01, 02 Mascom 32
Amstrad 03, 04, 05,
06, 31
Maspro 13
BT 01 Nokia 24, 26, 33
Canal+ 20 Pace 10, 25, 31
Canal
Satellite
20 Panasonic 15
D-Box 24 Philips 09, 23
Echostar 17, 18, 19,
21
Saba 35
Finlux11 Sagem 22, 29
Force 28 Salora 11
Galaxis 27 Selector 29
Grundig 07, 08 Skymaster 12, 36
Hirschmann 07, 17, 37 Thomson 35
ITT Nokia 11 TPS 22
Jerrold 16 Triax30
Kathrein 13, 14, 34 Wisi07
Luxor 11
Using the remote control for the
STB/VCR operation
Remote control button Usage
[STB/VCR A]Turns on/off the STB.
[STB] Selects the STB control
mode.
[CH +/-] Changes channels.
[the number buttons]
(1-9, 0)
Selects the channels.
Remote control button Usage
[STB/VCR A]Turns on/off the VCR.
[VCR] Selects the VCR control
mode.
[CH +/-] Changes channels.
[the number buttons]
(1-9, 0)
Selects the channels.
[;] Starts playback.
[o] Stops playback.
[W]Pauses playback.
[N]Fast-forwards the tape.
[O]Fast-rewinds the tape.
[REC w] + [;] Starts recording.
[REC w] + [W]Pauses recording.
To Next Page
Loading...
Need help?
General
