1-2 (No.MB294)
SPECIFICATION
Center unit (XV-THM508)
*1 : This value is measured at System cord CONNECTOR for reference.
*2 : Corresponding to Linear PCM, Dolby Digital, and DTS Digital Surround (with sampling frequency - 32 kHz, 44.1 kHz, 48 kHz)
*3 : For PAL system
Subwoofer (SP-PWM508)
Satellite Speakers-Front speakers (SP-THM508F)
Audio section Digital input*2 DIGITAL IN (DBS) (OPTICAL) -21 dBm to -15 dBm (660 nm E30 nm)
Video section Video System NTSC/PAL selectable
Horizontal Resolution 500 lines
Signal-to-Noise Ratio 64 dB
Video output level Composite 1.0 V(p-p)/75 Ω
S-video-Y 1.0 V(p-p)/75 Ω
S-video-C 0.286 V (0.3 V*3) (p-p)/75 Ω
Component-Y 1.0 V(p-p)/75 Ω
Component-PB/PR 0.7 V(p-p)/75 Ω
Video input sensitivity/
Impedance (VCR IN)
Composite 1.0 V(p-p)/75 Ω
S-video-Y 1.0 V(p-p)/75 Ω
S-video-C 0.286 V (0.3 V*3) (p-p)/75 Ω
Tuner section Tuning Range FM 87.50 MHz to 108.00 MHz
AM 531 kHz to 1 602 kHz (at 9 kHz intervals)
530 kHz to 1 600 kHz (at 10 kHz intervals)
General Power Requirements AC 110 - 240 V , 50/60 Hz (except for Australia)
AC 240 V , 50 Hz (for Australia only)
Power Consumption 18 W (at operation) 2.0 W (in standby mode)
Dimensions (W × H × D) 400 mm × 85 mm × 380 mm
Mass 4.3 kg
Amplifier section Front/Center/Surround 140 W per channel, RMS at 4 Ω (Center/Surround)/ 140 W per channel, RMS at 4 Ω
(Front) at 1 kHz, with 10 % total harmonic distortion.
Subwoofer 300 W, RMS at 4 Ω at 100 Hz, with 10 % total harmonic distortion.
Speaker section Speaker unit 25 cm Bass-reflex, Magnetically Shielded
Frequency Range 20 Hz to 200 Hz
General Power Requirements AC 110 V/127 V/220 - 240 V selectable with the voltage selector, 50 Hz/60 Hz
Power Consumption 170 W (at operation) 0 W (in standby mode)
Dimensions (W × H × D) 256 mm × 482 mm × 460 mm
Mass 18.5 kg
Speakers Woofer 10.0 cm × 2
Tweeter 4.0 cm, Bass-reflex, Magnetically Shielded
Power Handling Capacity 140 W
Impedance 4 Ω
Frequency Range 60 Hz to 20 kHz
Dimensions (W × H × D) 250 mm × 1065.5 mm × 310 mm
Mass 7.2 kg