10
English
CAUTION: The Volume cannot be adjusted while the Unit is on STANDBY.
DO NOT turn on the Unit and/or start playing any source without setting
the VOLUME control to 0; otherwise, the sudden blast of sound can
damage your hearing, speakers and/or headphones.
For private listening
Connect a pair of headphones to the PHONES jack. No sound comes out of the front speakers.
Be sure to turn down the volume before connecting or putting on headphones.
Balance Adjustment ————————————————————
You can use the remote control to adjust the left and right balance of the speakers.
1. Press and hold SHIFT B.
2. Press BALANCE L (10) or R (+10).
The display changes to show the balance adjustment.
Pressing L (10) moves the pointer to the left, pressing R (+10) moves the pointer to the right.
The balance is normally set to the center position.
Note: If no adjustments are made for 2 seconds, the display reverts to the previous display.
3. Release SHIFT B.
Reinforcing the Bass Sound
S.A. (Signal Adaptive) BASS adjusts low tones at low volume to enhance their effect. When the volume
level is low, this enhances low tones that are normally difficult to hear and adjusts low tones to a fixed
level to reduce low tone distortion.
Press S.A. BASS.
Each time you press the button, the bass setting changes as follows:
= SA-BASS1 = SA-BASS2 = OFF = (back to the beginning)
The S.A. BASS indicator lights up, and “SA-BASS1” or “SA-BASS2” appears on the display for 3 seconds.
SA-BASS2 enhances low tones more than SA-BASS1.
To cancel the effect, press S.A. BASS until “OFF” appears on the display. The button light goes out.
To recall the previous S.A. BASS mode, press S.A. BASS once.
When listening to recording with low volume low tones, the difference between SA-BASS1 and SA-
BASS2 is clear. When listening to recording with louder low tones, however, the difference between
SA-BASS1 and SA-BASS2 may not be so clear.
Muting Sounds
Press FADE MUTING on the remote control to turn down the volume.
To restore the previous volume level, press the button again.
You can also increase the volume by using VOLUME on the Unit or VOLUME + on the remote control.
L BALANCE R
Display when set for no
sound from the right speaker.
Display when set for no
sound from the left speaker.
Display at the
center position.
SHIFT B
S.A.BASS
or
FADE MUTING
EN01-13.CA-V908T[U]/f 98.7.22, 8:03 PM10
To Next Page
Loading...
Need help?
General
