Connections
Do not connect the power cord until all other connections have been made. I
Note that the illustration below is for SP-PWC6.
Before connecting the speaker cords;
Twist and pull the insulation coat oft and remove.
Powered subwoofer
TH-C7:SP-PWC7
TH-C6:SP-PWC6
TH-C5:SP-PWC5
TH-C4:SP-PWC4
TH-C3:SP-PWC3
Front speakers
TH-C7: SP-THC7F
TH-C6: SP-THC6F
TH-C5: SP-THC5F
TH-C4: SP-THC4F
TH-C3: SP-THC3F
@ @
\ !
Center speaker _
TH-C7: SP-THC7C _ l)
TH-C6: SP-THC6C
TH-C5: SP-THC5C
TH-C4: SP-THC4C
TH-C3: SP-THC3C
Speaker cord
• Connect Ibe black cords te the black (@) terminals.
• Connect the white cords to the (@) terminals
referring to the table below:
FRONT SPEAKEP, S (LEFT) White
FRONT SPEAKERS (RIGHT) Red
CENTER SPEAKER Green
SURROUND SPEAKERS (LEFT) Blue
SURROUND SPEAKERS (RIGHT) Gray
CAUTION
• When you connect speakers o/her than the supplied nnes, use
speakers of lhe same speaker impedance (SPEAKER IMPEDANCE)
indicated near the speaker terminals on the rear ol the powered
subwoofer.
• DO NOT connect more than one speaker to one speaker terminal.
Precautions for daily use
• When moving the speakers, do not pull the speaker cords;
otherwise, the speakers may fall over, causing damage or injury.
• Do not reproduce sounds at so high a volume Ibat they are
distorted; otherwise, the speakers may be damaged by internal
heat buildup.
(For TH-C7, TH-C6 and TH-C5)
• When holding a speaker, always grasp the lower portion.
• Do not lean against the speakers, as the speakers could fall down
or break, possibly causing an injury. Especially be careful that
children do not lean against them.
11
To Next Page
Loading...
Need help?
General
