– 7 –
Connecting Antennas
FM antenna
ANTENNA
FM(75
Ω)
COAXIAL
AM EXT
AM LOOP
1
Attach the FM antenna to the FM (75 Ω) COAXIAL
terminal.
2
Extend the FM antenna.
3
Fasten it up in the position which gives you the best
reception.
About the supplied FM antenna
The FM antenna supplied with this unit can be used as temporary
measure. If reception is poor, you can connect an outdoor FM
antenna.
ANTENNA
FM(75
Ω)
COAXIAL
AM EXT
AM LOOP
To connect an outdoor FM antenna
Before connecting it, disconnect the supplied FM antenna.
A 75 Ω antenna with coaxial type
connector (DIN 45325) should be used.
Outdoor FM antenna
(not supplied)
FM antenna (supplied)
ANTENNA
FM(75
Ω)
COAXIAL
AM EXT
AM LOOP
To connect an outdoor AM (MW/LW) antenna
When reception is poor, connect a single vinyl-covered
wire to the AM EXT terminal and extend it horizontally.
The AM (MW/LW) loop antenna must remain connected.
For better reception of both FM and AM (MW/LW)
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
1
If cords are covered with insulation, twist the core
of the cord at the end of each cord, then remove the
insulation.
2
Connect the AM (MW/LW) loop antenna to the AM
LOOP terminals as illustrated.
3
Turn the AM (MW/LW) loop antenna until you
have the best reception.
AM (MW/LW) antenna
AM (MW/LW) loop
antenna (supplied)
Vinyl-covered wire
(not supplied)
3
12
EN01-09UX-A52R[B]_f 01.12.4, 7:48 PM7
To Next Page
Loading...
Need help?
General
