– 8 –
Continued
Connecting Speakers
RL
––
+
+
RL
SPEAKER IMPEDANCE
MIN 4Ω
To connect speakers
You can connect the speakers by following the procedure
below:
1
If cords are covered with insulation, twist the core
of the cord at the end of each cord, then remove the
insulation.
2
Open the speaker terminal.
3
Insert the end of the speaker cord to the terminal.
Match the polarity: White cord to red (+) terminal and
black cord to black (–) terminal.
4
Close the speaker terminal on the rear of the unit.
Use only speakers with the speaker impedance—4 Ω to 16 Ω.
Speaker cord
Speaker cord
Black
Rear of the right
speaker
Rear of the left
speaker
Red
1
Speaker terminals
3,42
To remove the speaker grilles
The speaker grilles are removable.
Projections
Holes
To remove the speaker grille, insert your fingers at the top
of the speaker grille, then pull towards you. Do the same at
the bottom.
To attach the speaker grille, put the projections of the
speaker grille into the holes of the speaker.
Speaker grille
EN01-09UX-A52R[B]_f 01.12.4, 7:48 PM8
To Next Page
Loading...
Need help?
General
