Before initial operation
Unpacking
Carefully unpack the device and take care that all accessories are present:
Operating manual Remote control FM antenna R03/AAA 1.5 Volt Battery
Notes about reading the manual
Most functions can be controlled using the remote control.
Preparation of the remote control
• Insert the battery into the remote control, taking care that it is in the correct polarity (+ and -).
• The battery provided is intended for functional checking and can have a short service life.
• If the operating range of the remote control decreases, replace the old battery with a new one.
• If you expose the remote control sensor to direct sunlight or the light from high frequency
uorescentlamps,thismayleadtomalfunctions.Insuchsituations,youshouldsetupthesystem
at another place to avoid such malfunctions.
Connecting
• Carefully unpack the device and take care that all accessories are present.
• Connect the left and right speaker with the relevant
(Speaker Out) port on the side of the device.
•ConnectthemainsplugrmlytoanACoutlet.Asthemainsplugisusedasthe
disconnect device, the AC outlet shall be kept readily accessible.
FM antenna port
1. Connect the cable to the [AERIAL] jack.
2. Find a place where the best reception is achieved.
3. Fix the antenna in position.
• The antenna provided with the system is a simple dipole antenna. The use of a (commercially avail
able) outdoor antenna is recommended for stable signal reception. To connect an outdoor antenna,
rsttakeofftheindoorantenna.
6
To Next Page
Loading...
Need help?
General
