8
Listening to the Radio
To set the AM tuner interval spacing
Before operating the tuner, it is required to select the
appropriate AM space interval used for your area.
• This is possible only while the System is on standby.
1
Select the AM band.
2
Turn off the power.
3
Select the appropriate AM space interval for your
area.
To select the band (FM or AM)
To tune in to a station
While FM or AM is selected...
Frequency starts changing on the display.
When a station (frequency) with sufficient signal strength is
tuned in, the frequency stops changing.
• When you repeatedly press the button, the frequency
changes step by step.
To stop searching manually,
press either button.
If the FM station has poor reception
The MONO indicator lights on the display. Reception will
improve though stereo effect is lost—Monaural reception.
To restore the stereo effect,
press the button again (the
MONO indicator disappears).
To preset the stations
You can preset 30 FM and 15 AM stations.
1
Tune in to a station you want to preset.
• You can also store the monaural reception mode for FM
preset stations if selected.
2
Activate the preset number entry mode.
• Finish the following process while the indication on the
display is flashing.
INFO
Main Unit
ONLY
TUNER FM
TUNER AM
AM 9KHZ
DOWN
AM 10KHZ
UP
(while holding...)
(while holding...)
(9 kHz interval)
(10 kHz interval)
Remote control:
Main unit:
Remote control: Main unit:
GROUP/TITLE SKIP
2 sec.
2 sec.
DOWN
UP
Remote
ONLY
FM/PLAY MODE
PA G E
Remote
ONLY
MONO
MP3
PL
PG
WMA
PRGR.
3D PHONIC
B.S.P. BONUS
ST
TA
NEWS INFO
AHB PRO
A.STBY
123
S.TURBO
SLEEP
PRGM
QP Link
USB
REC
REC
1
RANDOM
GROUP
DISC ALL A–B
ENTER/SET
UX-G70[U].book Page 8 Monday, April 17, 2006 5:18 PM
To Next Page
Loading...
Need help?
General
