EasyManuals Logo
Home>JVC>Stereo System>UX-G950V

JVC UX-G950V User Manual

JVC UX-G950V
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
6
To connect the powered subwoofer
The connected subwoofer can reproduce the bass sounds
recorded in front left and right channels, but cannot
reproduce the LFE signals encoded in multi-channel
software.
Before plugging the System to the power supply, make
sure that the powered subwoofer is turned off.
@ TV/monitor
Connect either component cord or SCART cord.
This connection allows you to use the progressive
scanning mode. To select progressive (PROGRE)
scanning mode (see page 16), use VIDEO OUT
(COMPONENT) jacks.
This connection sends the
video signal (Composite, Y/C,
or RGB) and receives audio
signal from TV. To listen to
the TV sound, see page 10.
After connecting a TV, select the appropriate video
signal output according to the connection method. See
“Changing the Scanning Mode” on page 16.
When connecting a USB mass storage class device
From the powered subwoofer
(not supplied)
Green
Red
Blue
Component video
cord (not supplied)
SCART cord
(not supplied)
On the front panel
When connecting with a USB cable, use the USB 2.0 cable
whose length is less than 1 m.
You can connect a USB mass storage class device such as
a USB flash memory device, hard disk drive, multimedia
card reader, etc. to this System.
You cannot connect a computer to the USB MEMORY
REC/PLAY (
) terminal of the System.
You cannot connect JVC Everio camcorder to the USB
MEMORY REC/PLAY (
) terminal of the System.
Noise and static electricity may stop the USB mass
storage class device sound. In this case, disconnect and
connect the USB mass storage class device again after
turning off the System.
When connecting a digital audio player
Preparing the remote control
Insert the battery into the remote control by matching the
polarity (+ and –) correctly.
If the range or effectiveness of the remote control decreases,
replace both batteries.
Caution
Battery shall not be exposed to excessive heat such as
sunshine, fire, or the like.
When using the remote control
Point the top of the remote control towards the remote
sensor as directly as possible. If you operate it from a
diagonal position, the operating range (approx. 5 m) may
be shorter.
Stereo mini plug (not supplied)
On the front panel
From audio output (or
headphone out, etc.)
USB cable (not supplied)
EN_UX-G950V[B]5.indb 6EN_UX-G950V[B]5.indb 6 08.4.18 5:32:00 PM08.4.18 5:32:00 PM

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JVC UX-G950V and is the answer not in the manual?

JVC UX-G950V Specifications

General IconGeneral
BrandJVC
ModelUX-G950V
CategoryStereo System
LanguageEnglish

Related product manuals