1-7
UX-V30
Prior to performing the following procedure, remove
the rear cover, the side panels and the cassette
mechanism assembly.
Disconnect the card wire from connector CN1 on the
tuner & function board.
Remove the screw H attaching the tuner & function
board.
Release the two joints e and the joint f of the tuner &
function board.
1.
2.
3.
Removing the tuner & function board
(See Fig.14)
Prior to performing the following procedure, remove
the rear cover, the side panels and the cassette
mechanism assembly.
Disconnect the harness from connector CN902 on
the power transformer.
Disconnect the harness from connector CN901 on
the AC supply board.
Remove the four screws I attaching the power
transformer.
1.
2.
3.
Removing the power transformer
(See Fig.15)
*Prior to performing the following procedure, remove
the rear cover, the side panels and the cassette
mechanism assembly.
Disconnect the harness from connector CN901 on
the AC supply board.
Remove the screw F attaching the heat sink on the
back of the body (Refer to Fig.9).
Remove the two screws J attaching the AC supply
board.
1.
2.
3.
Removing the AC supply board
(See Fig.15)
To remove the AC supply board
efficiently, remove the main board in
advance.
ATTENTION:
Fig.14
Fig.15
Joint e
Joint f
Tuner
& function board
CN1
H
Power transformer board
Main board
Heat sink
AC supply board
CN902
CN901
I
I
J
J
To Next Page
Loading...
Need help?
General
