Kärcher BD 38/12 C Bp User Manual

– 13
 DANGER
Risk of injury. Turn the appliance
switch to "0" and pull the mains plug of
the charger prior to performing any
work on the appliance.
ATTENTION
Risk of damage for the appliance due
to leaking water. Drain the wastewater
and remaining fresh water prior to per-
forming tasks on the appliance.
In case of faults that cannot be reme-
died using the table below please con-
tact the customer service.
Faults
Fault Remedy
Appliance cannot be started Switch on the appliance switch, wait 3 seconds,
check charge condition of the battery.
Insufficient water quantity Check fresh water level, refill tank if necessary.
Switch on "Detergent" button.
Open the dosing device for the cleaning solution.
Clean the fresh water filter.
Insufficient vacuum perfor-
mance
Lower the vacuum bar.
Empty the waste water tank.
Clean the seals between waste water tank and cover
and check for tightness, replace if required.
Clean the vacuum lips on the vacuum bar, turn or re-
place if required
Check if the suction hose and vacuum bar are
chocked, clean if required
Check the suction hose for tightness; replace if re-
quired.
Insufficient cleaning result Check the brush type and the detergent for their suit-
ability.
Check the brushes for wear, replace if required.
Brush does not turn Pull the safety switch towards the steering wheel.
Check the brush for blockage by foreign objects; re-
move the foreign objects.
Switch off the switch for the brush drive, wait for a
short period of time, switch the switch back on.
15EN

Kärcher BD 38/12 C Bp Specifications

General

Maximum input power	500 W
Maximum area performance	1500 m²/h
Waste container capacity	1 L
Fresh water tank capacity	12 L
Brush rotation speed (min)	180 RPM
Practical area performance	1050 m²/h
Battery voltage	25.2 V
Battery capacity	21 Ah

Weight and Dimensions

Depth	500 mm
Width	940 mm
Height	1100 mm
Weight (including battery)	36000 g