– 7
1 Dosage cleaning solution
2 Switch for detergent solution
3 Control lamp to apply detergent so-
lution
4 Indicator lamp vacuuming
Green: Suction turbine in operation
Orange, flashing: Suction turbine
overloaded
5 Indicator lamp brush drive
Green: Brush is rotating
Orange, flashing: Brush overloaded
6 Battery status display
Green Battery charged
Orange: Battery almost empty
Red Appliance swithces off: Load
battery
7 Indicator lamp Eco mode
8 Switch Eco mode
9 Power switch
Note:
The device is equipped with a safety
mechanism to prevent total discharge,
i.e. when the permissible minimum ca-
pacity is reached, the machine will be
shut off.
The charging process takes approx. 3
hours.
The charger automatically switches off
the charging process.
If necessary, the appliance can be
used again before the battery has been
fully charged.
Insert the mains plug into the sock-
et.
1 Battery is charged (green)
2 Battery is being charged (yellow,
flashing)
3 Malfunction (red)
Release the star knob for the trans-
port position.
Adjust the push rod to the desired
height.
Tighten the star handle.
Install the disc brush (see "Mainte-
nance and Servicing")
ATTENTION
Risk of damage. Only use the recom-
mended detergents. With other deter-
gents, the operator bears the
increased risk regarding the operation-
al safety, risk of accident and reduced
service life of the appliance. Only use
detergents that are free of solvents, hy-
drochloric acid and hydrofluoric acid.
Follow the safety instructions for using
detergents.
Before Startup
Charging battery
Battery charging display
Operation
Filling in detergents
9EN
To Next Page
Loading...
Need help?
General
Weight and Dimensions
