English 11
Note
We recommend that you use our microfilter
attachment set along with the paper bag
(see special accessories). BIA category C,
separation level safety greater than 99.9%.
This can help in sucking even extremely fine
dust particles that can be harmful to health.
The microfilter should be replaced when the
suction performance is poor despite chang-
ing the paper bag.
Î Remove both the screws located on the
sides of the upper part of the vacuum
cleaner.
Î Insert the upper part of the vacuum
cleaner in a vertical position on to the
brush head.
Î Insert both the aluminium profiles into
the recesses provided at the upper part
of the vacuum cleaner and fasten them
with the screws.
Î Connect the connecting hose to the
brush head and the upper part of the
vacuum cleaner.
Î Insert the connection chord with plug into
the socket at the upper part of the vacu-
um cleaner (you must be able to hear the
plug locking in).
Î Wind the mains cable of the appliance
between the upper and lower cable hold-
er.
Î Remove the entire mains cable by turn-
ing the lower cable holder.
몇 Warning
Risk of damage! Do not move the appliance
over the mains cable when the brushes are
rotating. Carry the appliance over the steps
and high thresholds.
The brush head is equipped with a hinged
lock that stops the appliance in the vertical
resting position.
Î To resume working, step on the locking
pedal and tilt the appliance backwards.
Start up
Connecting the upper part of the
vacuum cleaner with the brush head
Operations
Storing and removing the cable
Working/ resting position
To Next Page
Loading...
Need help?
General
