English 9
Detergents can only be applied at
low pressure (Min).
" STEP 1: Install the Vario Power
Spray Wand. Set the wand to the lo-
wer pressure setting (Min).
" STEP 2: Fill a container with Kärcher
Ready to use detergent. Place the
filter end of detergent suction tube
into a container.
" STEP 3: Turn on the pressure was-
her (1). Pull trigger to operate unit:
Liquid detergent is drawn into the
unit and mixed with water (detergent
suction 0.07 - 0. 08 GPM). Apply de-
tergent to work area. Do not allow
detergent to dry on surface.
For best results see Cleaning Tips on
pages 11 & 12 for specific informati-
on on how to clean different sur-
faces.
Always Use Kärcher Detergent for
Best Results
Kärcher biodegradable detergents are
specially formulated to protect the envi-
ronment and your pressure washer.
Special formula won’t clog the suction
tube filter and will protect the internal
parts of the pressure washer for a lon-
ger life. For Kärcher Detergents, check
your retailer or call our service center for
help.
The following Kärcher detergents are
available:
One Gallon ready to use
! Vehicle Wash
! All Purpose Cleaner
! Deck Wash
! Degreaser
! House Wash
CAUTION
Never use:
– Bleach, Chlorine products and other
corrosive chemicals
– Liquids containing solvents (i.e.,
paint thinners, gasoline, oils)
– Tri-sodium phosphate products
– Ammonia products
– Acid-based products
These chemicals will harm the unit and
will damage the surface being cleaned.
WORKING WITH DETERGENTS
To Next Page
Loading...
Need help?
General
