Kärcher SC 3 Upright EasyFix User Manual

English 15
Keep the device safe
ATTENTION
Material damage due to condensate/
moisture
The floor covering can be damaged by
moisture remaining on the floor clean-
ing cloth or floor nozzle/device after
cleaning.
Remove the floor cleaning cloth/carpet
glider and dry the floor nozzle/the de-
vice after finishing the floor cleaning
work.
Do not place or store the device on
heat-sensitive surfaces.
1. Remove the floor cleaning cloth or
floor cleaning cloth and carpet glid-
er, see the chapter "Floor nozzle
and carpet glider".
2. Remove moisture from the floor noz-
zle/device.
3. Wind the power cable around the
upper and lower cable holders.
4. Store the device in vertical position
on a solid base or on the wall.
5. Store the device in a dry location
that is protected from frost.
Important application
instructions
Cleaning the floor areas
We recommend sweeping the floor or
vacuum cleaning it before using the
device. In this way the floor will be
cleared of dirt and loose particles be-
fore the wet cleaning commences.
1.
2.
1.
2.

Kärcher SC 3 Upright EasyFix Specifications

General

Type	Steam mop
Capacity	0.5 L
Control type	Buttons
Product color	Black, Grey, Yellow
International Protection (IP) code	IPX4
AC input voltage	220 - 240 V
AC input frequency	50 - 60 Hz
Ready time	0.5 min
Steam pressure	- bar
Adjustable steam	Yes
Continuous steam performance	40 g/min
Cable length	5 m
Steam-ready light	-

Weight and Dimensions

Depth	314 mm
Width	207 mm
Height	1185 mm
Weight	3100 g