English 9
1 Button / switch range
2 Switch - Off
3 Switch - On
4 Indicator lamp (red)
- Replacement of the decalcifica-
tion cartridge.
5 RESET button
- Setting the water hardness
- Confirmation after changing the
cartridge
6 LED operating indicator
Flashing red - mains voltage pres-
ent and device is heating up
Green - device is ready for opera-
tion
7 Display for steam stage setting
8 Button for steam stage setting
9 Steam stage 1 - Wood
10 Steam stage 2 - Carpet
11 Steam stage 3 - Tiles/Stone
12 Handle
13 Wall anti-slip handle
14 Steam lever
15 Cable holder with cable fastener
16 Decalcification cartridge
17 Filling hole for water
18 Water reservoir with reservoir cover
and carrying handle
19 Mains connection cable with mains
plug
20 Unlocking button for floor nozzle
21 Floor nozzle
22 Hook and loop fastening
23 Microfiber floor cloth (2 x)
24 Carpet glider
Initial commissioning
ATTENTION
Device damage due to calcification
The decalcification cartridge only
works properly if you adjust the device
to the local water hardness before op-
erating it for the first time.
Set the device to the local water hard-
ness.
Set the device to the current water
hardness before using it in an area with
a different water hardness (e.g. after a
move)
1. Insert the decalcification cartridg
e
into the water reservoir and press it
firmly into place.
2. Set the water hardness, see chapter
Setting the water hardness.
Note
When steaming for the first time after
removing and reinserting the decalcifi-
cation cartridge, the steam jet may be
weak or irregular, and individual drops
of water may be expelled. The device
requires a short warm-up period during
which the decalcification cartridge fills
with water. The steam volume that is
expelled increases constantly until the
maximum steam volume has been
reached after approx. 30 seconds.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
