EasyManuals Logo
Home>Kärcher>Vacuum Cleaner>VC 4 Cordless myHome

Kärcher VC 4 Cordless myHome User Manual

Kärcher VC 4 Cordless myHome
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
10 English
2. Remove the suction pipe or accessory.
3. Empty the dust container into a waste container.
a Press the unlocking button.
The dust container flap opens.
b Empty the dust container.
Illustration J
4. To close the flap, push the dust container upwards
until it clicks into place.
5. Clean the air inlet filter, see chapter Cleaning the air
inlet filter
6. Attach the device to the wall bracket.
Illustration E
7. Charge the device, see chapter Battery charging.
How to use the Accessories
General instructions for use
Which accessories are included in the scope of de-
livery is shown on the device packaging.
Accessories not included in the packaging can be
purchased in a KÄRCHER specialist shop or fr
om
w
ww.kaercher.com.
Test the accessory at an inconspicuous point before
using it in a sensitive area.
Follow the manufacturer's cleaning instructions.
Connect the motor-driven electric nozzle to the suc-
tion pipe or the hand-held device.
Also connect the other accessory parts, such as
crevice nozzle, to the hand-held device or push it di-
rectly onto the suction pipe to increase the reach.
Motor-driven multi-function brush
Ideal for hard floors and carpets.
The motor-driven multi-function brush removes dirt
stuck between the carpet fibres particularly effectively.
2-in-1 upholstery nozzle
The frame with the surrounding bristles can be taken off
pressing the unlocking button.
The soft brush is suitable for furniture with hard sur-
faces
The wide brush is used to clean upholstered furni-
ture, curtains, etc.
Crevice nozzle
For edges, joints, heaters and areas that are difficult to
reach.
Soft brush
The soft brush has particularly soft bristles for cleaning
sensitive surfaces such as keyboards, lamps, etc.
Flexible crevice nozzle
The flexible crevice nozzle increases the reach. For
cleaning hard-to-reach places, such as between the car
seats.
Flexible extension hose
Due to the extension and flexibility, hard-to-reach areas
such as in the car can be reached and cleaned.
Large upholstery nozzle
For cleaning textile surfaces such as sofas, armchairs,
mattresses, car seats, etc.
2-in-1 furniture brush
For gentle cleaning of sofas and delicate furniture. De-
pending on requirements, the accessory can be used as
a furniture or upholstery nozzle by pressing the button.
Mini turbo brush
Efficiently removes pet hair and dust particles from up-
holstered furniture, mattresses or other soft surfaces.
The rotating round brush catches even the finest hair.
LED-crevice nozzle
For cleaning corners and hard-to-reach areas. The illu-
mination makes even the finest dust visible in dark
spaces.
Soft motor-driven brush (Hard floor nozzle)
For hard floors and sensitive wooden floors. Extracts
coarse and fine dirt simultaneously.
Transportation
The battery has been tested in accordance with the rel-
evant rules for international transport, and can be
transported / shipped.
Storage
ATTENTION
Moisture and heat
Risk of damage
Store batteries only indoors in a dry place with low hu-
midity and temperatures below 20°C.
Care and service
General care instructions
Clean the device and plastic accessory parts with a
commonly available plastic cleaner.
Cleaning the air inlet filter
Note
The device can be cleaned manually or using a filter
cleaning device.
1. Switch off the device.
2. Manually cleaning the air inlet filter.
a Pull the soiled air inlet filter down at the filter stick,
carefully beat it and clean it with a damp cloth or
running water.
Illustration K
b Reinsert the fully dried air inlet filter.
c Check for correct seating.
3. Cleaning the air inlet filter with a filter cleaning
device.
Note
A new air inlet filter must be installed in the dust contain-
er during filter cleaning.
a Push the filter cleaning device on to the suction
pipe branch and pull the air inlet filter out of the
device using the filter stick.
b Push the soiled air inlet filter into the filter clean-
ing device.
c Insert a new air inlet filter into the dust container.
Illustration L
d Switch on the device and let it run in boost mode
while turning the side cover.
Illustration M
e Remove the cleaned air inlet filter from the filter
cleaning tool and reinsert it in the dust container
after removing the new air inlet filter.
f Check that the air inlet filter is correctly seated.

Other manuals for Kärcher VC 4 Cordless myHome

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kärcher VC 4 Cordless myHome and is the answer not in the manual?

Kärcher VC 4 Cordless myHome Specifications

General IconGeneral
Noise level75 dB
Cleaning typeDry
Number of speeds2
Filtration systemYes
Vacuum air filtering-
Dirt separating methodCyclonic
Product colorBlack, Yellow
Dust container typeBagless
Battery typeBuilt-in
Power sourceBattery
Charging time5.75 h
Battery voltage21.6 V
AC input voltage220 - 240 V
Battery capacity2.5 Ah
AC input frequency50 - 60 Hz
Package weight4400 g
Quantity per pack1 pc(s)
Vacuum brushes includedHard floor brush
Weight and Dimensions IconWeight and Dimensions
Depth230 mm
Width236 mm
Height1130 mm
Weight1115 g
Weight (without accessories)2400 g

Related product manuals