23
Certifications
6.1 CE-Marking
CE marked frequency inverter and servo drives were developed and manufactured to
comply with the regulations of the Low-Voltage Directive 73/23/EEC.
The inverter / servo drive must not be started until it is determined that the installation
complies with 89/392/EEC (machine directive) as well as the EMC-directive (89/336/
EEC)(note EN60204).
The frequency inverters / servo drives meet the requirements of the Low-Voltage Directive
73/231/EEC. The harmonized standards of the series EN 50178 in connection with EN
60439-1 and EN 60146 were used.
This is a product of limited availability in accordance with IEC 61800-3. This product may
cause radio interference in residential areas. In this case the operator may need to take
corresponding measures.
6.2 Manufacturer´s Declaration
A manufacturer declaration in accordance with 89/392/EEC can be provided by KEB if
needed.
6.3 UL / CUL - Marking
6. Certifications
To be conform according to UL and CUL for the use on the North
American and Canadian Market the following instructions must be
observed:
• Inverter is suitable for use on a circuit capable of delivering not more than 10 kA rms
(symmetrical), 240 V AC or 480 V AC maximum
• Maximum surrounding air temperature 45 °C (113 °F)
• For control cabinet mounting as „Open Type“
• For use in a pollution degree 2 environment
• Motor protection by adjustment of current parameters
• Not incorporated with overspeed protection
• Power terminal tightening torque (see type plate)
• Control terminal tightening torque (see chapter 3.4)
• Overload protection at 130 % of inverter output rated current (see type plate)
• Refer to this installation instructions for proper wiring
C
To Next Page
Loading...
Need help?
General