14
CERTIFICATION
2 Certication
2.1 CE-Marking
CE marked drive converters were developed and manufactured to comply with the reg-
ulations of the Low-Voltage Directive and EMC directive. The harmonized standards of
the series EN 61800-5-1 and EN 61800-3 were used.
This is a product of limited availability in accordance with EN 61800-3. This product may
cause radio interference in residential areas. In this case the operator may need to take
corresponding measures.
The inverter / servo drive must not be started until it is determined that the installation
complies with the machine directive as well as the EMC-directive (note EN60204).
2.2 Functional safety
Driver converters with functional safety are marked with the FS
logo on the type plate. These units are designed and manufac-
tured in accordance with the Machine Directive. The harmonized
standard of the serie EN 61800-5-2 were used.
2.3 UL Certications
Acceptance according to UL is marked at KEB
devices with the adjacent logo on the type
plate.
The validity of the acceptance is only valid if the instructions given in the instruction
manual are observed.
2.4 Further information and documentation
Youcan ndadditionaldocumentationfordownloadat"www.keb.de"byenteringthe
materialnumberinthesearcheld.
Manuals - further parts of the instruction manual
Drawings - various formats for 3-models (e.g. Step)
Software - Operating software COMBIVIS and driver
Certicates-Declarationofconformity,TÜVcerticates
FAQ - Technical infos and FAQs
EPLAN - Connection drawings
To Next Page
Loading...
Need help?
General