6
BASIC SAFETY INSTRUCTIONS
1 Basic Safety Instructions
The COMBIVERT is designed and constructed in accordance with state-of-the-art tech-
nology and the recognised safety rules and regulations. However, the use of such devic-
es may cause functional hazards for life and limb of the user or third parties, or damages
to the system and other material property.
The following safety instructions have been created by the manufacturer for the area
of electric drive technology. They can be supplemented by local, country- or applica-
tion-specicsafetyinstructions.Thislistisnotexhaustive.Non-observancewillleadto
the loss of any liability claims.
Attention
Hazards and risks through ignorance.
► Read the instructions for use!
► Observe the safety and warning instructions !
► If anything is unclear, please contact KEB !
1.1 Target group
This instruction manual is determined exclusively for electrical personnel. Electrical per-
sonnelforthepurposeofthisinstructionmanualmusthavethefollowingqualications:
• Knowledge and understanding of the safety instructions.
• Skills for installation and assembly.
• Start-up and operation of the product.
• Understanding of the function in the used machine.
• Detection of hazards and risks of the electrical drive technology.
• Knowledge of DIN IEC 60364-5-54.
• Knowledge of national safety regulations (e.g. DGUV Vorschrift 3).
1.2 Specied application
The COMBIVERT serves exclusively for the control and regulation of three-phase mo-
tors. It is intended for the installation into electrical systems or machines.
Technical data and information for connection conditions shall be taken from the type
plate and from the instruction manual and must be strictly observed.
The used semiconductors and components of the KEB Automation KG are developed
and dimensioned for the use in industrial products.
The COMBIVERT meets the requirements of the Low-Voltage Directive. The harmo-
nized standards of the series EN 61800 for drive converters were used.
The COMBIVERT is a product of limited availability in accordance with EN 61800-3. This
product may cause radio interference in residential areas. In this case the operator may
need to take corresponding measures.
The machine directive, Low Voltage Directive, EMC directive, RED and other guidelines
and regulations must be observed depending on the version.
To Next Page
Loading...
Need help?
General