REASSEMBLY AND REMOUNTING
Reassemble and remount the rear wheel and brake in
the reverse of removal, and also carry out the following steps:
□ Turn the punched mark① on the camshaft to the
Rear axle shaft side.
□ Install the protrusion ② of indicator plate to the groove ③ of
Camshaft.
□ When installing the brake cam shaft, aligh the groove ④ of camshaft
With the slit ⑤ of on cam shaft.
□ When installing brake shoes, be sure to daub camshaft with
Adequate grease.
CAUTION:
Be careful not to daub the camshaft with too much grease.
If grease gets on the lining, brake effectiveness will be lost.
To Next Page
Loading...
Need help?
General
