2400S-903-01 Rev. E / September 2011 Return to Section Topics 1-5
Series 2400 SourceMeter® Quick Start Guide Section 1: Introduction
• DISPLAY EDIT — Selects the source or compliance display field for editing. A blinking
cursor will appear in the field to be edited. If no key is pressed within a few seconds, the edit
mode will be cancelled automatically.
• EDIT arrow keys — Places the display cursor on the display digit to be changed.
• SOURCE arrow keys
— Increments or decrements the source or compliance value. Note
that pressing either of these keys will automatically enable the source edit mode.
• RANGE arrow keys
— Selects the source or compliance range.
• Numeric keys (0-9) — Allow you to directly enter source or compliance values.
• EXIT — Exits the edit mode without waiting for the time-out period.
Editing procedure
1. Press the DISPLAY EDIT key to place the blinking cursor in either the source or compliance
display field to be edited.
2. If desired, use the RANGE arrow keys to select the desired source or compliance range.
3. To simply increment or decrement the display value, use the EDIT arrow
keys to place the
blinking cursor on the digit to be changed, then increment or decrement the value with the
SOURCE arrow keys. Note that the source or compliance value will be updated immedi-
ately; you need not press ENTER to complete the process.
4. To enter the source or compliance value directly, simply key in the desired value with the
numeric keys while the cursor is blinking. Again, the source or compliance value will be
updated immediately.
Toggling the source and measure display fields
Normally, the measured reading value will appear in the upper, main display line, while the source
and compliance values will appear in the left and right fields respectively of the lower display line.
You can toggle the source and measure display fields by pressing the DISPLAY TOGGLE key to
place the source and measure values in the desired display fields.
To Next Page
Loading...
Need help?
General
