10
REFRIGERATOR INSTA LLATION
WA RN I N G
Excessive Weight Hazard:
Use two or more people to move and install the
refrigerator. Failure to do so can result in back or other
injury.
UNPACKING YOUR REFRIGERATOR
Remove tape and any temporary labels from your
refrigerator before using. Do not remove any warning- type
labels, the model and serial number label, or
the Tech Sheet that is located under the front of the
refrigerator.
To remove any remaining tape or glue, rub the area briskly
with your thumb. Tape or glue residue can also be easily
removed by rubbing a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm water
and dry.
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your refrigerator.
Refrigerator shelves are installed in the shipping position.
Please reinstall shelves according to your individual storage
needs.
Remove all cantilevered ref rigerator compartment shelves
and remove the protective shipping tape found on the
attachment hooks at back of shelves. For shelf removal
instructions, see Ref rigerator Shelves in USING YOUR
REFRIGERATOR section of this Use & Care Guide.
WA RN I N G
Excessive Weight Hazard:
Your refrigerator is heavy. When moving the refrigerator
for cleaning or service, be sure to protect the floor.
Always pull the refrigerator straight out when moving
it. Do not wiggle or walk the refrigerator when trying to
move it, as floor damage could occur.
WA RN I N G
Explosion Hazard:
Keep flammable materials and vapors, such as gasoline,
away from the refrigerator. Failure to do so can result in
fire, explosion, or death.
To Next Page
Loading...
Need help?
General
