- 24 -
Vacuum cleaner 1. Unplugged at wall outlet. 1. y, move switch to
won’t start. FLOOR or CARPET position.
2. Tripped circuit breaker/ 2. Reset circuit breaker or replace
blown fuse at household fuse.
service panel.
3. Loose hose electrical 3. Reconnect hose ends.
connections.
Poor job of dirt 1. Full or clogged dust cup. 1. Empty and clean dust cup.
pick-up. 2. Cloggeow passages. 2. Cleow passages.
3. Dir. 3. Change/cle
4. Wrong pile height setting. 4. Adjust setting.
5. Suction control is open. 5. Adjust control.
6. Hole in hose. 6. Replace hose.
7. Worn PowerMate
®
agitator. 7. Change agitator.
8. Worn or broken belt. 8 & 9. See BELT CHANGING AND
9. Dirty agitator or end caps. AGITATOR CLEANING.
10. Dust cup installed 10. See EMPTYING DUST CUP.
incorrectly.
11. Dust cup lid and dust cup 11. See PRE-FILTER CLEANING.
missassembly.
Vacuum cleaner starts 1. Hose electrical connection. 1. Check connections, reconnect
but shuts o. hose ends.
2. Tripped overload protector 2. Remove any items that may be
in PowerMate
®
. caught or jammed, then reset. If
vacuum cleaner starts and stops
again, clean agitator and end
caps, then reset.
3. Tripped thermal protector 3. Reset thermal protector.
in canister.
PowerMate
®
will not 1. PowerMate
®
connections 1. y.
run when attached. unplugged.
2. Worn or broken belt. 2 & 3. See BELT CHANGING AND
3. Dirty agitator or end caps. AGITATOR CLEANING.
4. Tripped overload protector 4. Remove any items that may be
in PowerMate
®
. caught or jammed, then reset. If
vacuum cleaner starts and stops
again, clean agitator and end
caps, then reset.
5. Switch not in CARPET 5. Move switch to CARPET position.
position.
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
Revieyourself solutions for minor performance problems. Any other
service needed should be performed by a Seed service agent.
TROUBLESHOOTING
WARNING
Alwvacuum cleaner
before performing maintenance to the
vacuum cleaner
.
Failure to do so could result in electrical shock or personal injury.
To Next Page
Loading...
Need help?
General
