Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Setting the Clock
Setting the Clock
The pad is used to set the clock. The clock may be set for 12 or 24 hour time of day operation. The clock has been preset
at the factory for the 12 hour operation. When the range is rst plugged in, or when the power supply to the range has been
interrupted, the time in the display will ash.
Press
. The display will stop ashing.
1. Press . "CLO" will appear in the display (Fig. 1).
2. Press pads to set the time of day to 1:30 (Fig. 2). Press .
The time of day will appear in the display (Fig. 3).
1. Press and hold for 7 seconds until "" or "" appears in
the display.
2. Press
to switch between the 12 and 24 hour time of day display.
The display will show either "" (Fig. 4) or "" (Fig. 5).
3. Press
to accept the change or press to reject the change.
4. Reset the correct time as described in To set the Clock above. Please
note that if the 24 hour time of day mode was chosen, the clock will
now display time from 0:00 through 23:59 hours.
for 7 seconds
or press
To Next Page
Loading...
Need help?
General