24
Changing the Filter
Locating the Filters
Your refrigerator is equipped with water ltering system.
The water lter system lters all dispensed drinking water,
as well as the water used to produce ice.
Water Filter
The water lter is located at the top right side of the fresh
food compartment.
Ordering Replacement Filters
To order your replacement lters, please visit the dealer
where you purchased your refrigerator. Sears recommends
that you order extra lters when you rst install your
refrigerator, and that you replace your lters at least once
every six months.
Here is the product number to request when ordering:
Kenmorepure!
TM
Water Filter
Part #9919
Replacing the Water Filter
In general, you should change the water lter every
six months to ensure the highest possible water quality.
Water Filter Status on the user interface prompts you to
replace the lter after a standard amount of water (200
gallons/757 liters for Kenmorepure!
TM
) has owed through
the system.
If your refrigerator has not been used for a period of time
(during moving for example), change the lter before
reinstalling the refrigerator.
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or
after the system. Systems certied for cyst reduction may be
used on disinfected waters that may contain lterable cysts.
Test & Certication Results:
• Rated Capacity - 200 gallons/757 liters for
Kenmorepure!
TM
ice and water lter
• Rated service ow - .50 gallons per minute (1,9 L/
minute)
• Operating Temp.: Min. 33°F (0,5°C), Max. 100°F
(37,7°C)
• Maximum Rated Pressure - 100 pounds per square inch
• Recommended Minimum Operating Pressure: 30
pounds per square inch (206kPa)
To Replace your Kenmorepure!
TM
Water Filter:
It is not necessary to turn the water supply o to change
the lter. Be ready to wipe up any small amounts of water
released during the lter replacement.
1. Turn O the ice maker power switch.
2. Remove the lter by pushing on the end/face of the
lter.
3. Slide the old water lter cartridge straight out of the
housing and discard it.
4. Unpackage the new lter cartridge. Using the
alignment guide, slide it gently into the lter housing
until it stops against the snap-in connector at the
back of the housing.
5. Push rmly until the cartridge snaps into place (you
should hear a click as the cartridge engages the
snap-in connector).
6. Press a drinking glass against the water dispenser
while checking for any leaks at the lter housing.
Any spurts and sputters that occur as the system
purges air out of the dispenser system are normal.
7. After lling one glass of water, continue ushing the
system for about three minutes.
8. Turn On the ice maker.
9. Press and hold the Water Filter button on the Ice &
Water Dispenser control panel for three seconds.
When the display changes from Red to Green, the
status has been reset.
The Kenmorepure!
TM
ice and water lter system
is tested and certied to NSF/ANSI Standards
42 and 53 for the reduction of claims specied
on the performance data sheet.
More about your Advanced Water Filter
NOTE
When ordering your replacement lter, please reorder
the same lter type that is currently in your refrigerator.
To Next Page
Loading...
Need help?
General