ASSEMBLY INSTRUCTIONS
Please pay special attention to these hazard alert boxes, and follow any instruc-
tions given. WARNING statements alert you to such dangers as fire, electric
shock, burns and personal injury. CAUTION statements alert you to such dangers
as personal injury and/or property damage.
WARNING
Electrical Shock Hazard
DO NOT plug into electrical supply until
assembly is complete. Failure to do so
could result in electrical shock or injury.
HANDLE ASSEMBLY
Insert wand into
handle until lock
button snaps in
place.
To remove: Press
wand release button
and pull up on
handle.
To store: Disconnect
hose from wand and
canister to prevent
stress on hose during
storage. Store hose
in a loosely coiled
position so the hose
covering is not stressed.
- 8 -
POWERMATE
®
Align wand and insert
onto PowerMate
®
until
the wand locks into
place.
WAND (TELESCOPING)
The wand length is
adjustable and requires
no assembly.
To adjust, simply push
on the wand adjust
button and slide the
upper wand to the
desired height.
NOTE: When adjusting
the wand length you
may have to hold the
PowerMate
®
down
with your hand or foot.
Before assembling vacuum cleaner, check the PACKING LIST (page 2). Use this list to
verify that you have received and identified all the components of your new Kenmore
vacuum cleaner.
ATTACHMENT HOLDER
Align the attachment holder clip with the
front of wand. Push and snap into place
on wand.
To Next Page
Loading...
Need help?
General
