EasyManuals Logo
Home>Kenmore>Vacuum Cleaner>BC7005

Kenmore BC7005 User Manual

Kenmore BC7005
77 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
DIRT SENSOR
The dirt sensor is located on the floor brush.
When the vacuum cleaner is in use, with the
switch in the CARPET position, the blue light
on the top of the brush will illuminate to show
that dirt is being vacuumed. As long as the
light is on, dirt is passing across the sensor to
indicate that the surface still needs cleaning.
When the sensor light turns o, the sensor is
not seeing enough dirt to warrant further
cleaning of that area.
TO CLEAN DIRT SENSOR LENSES
The dirt sensor lenses are located on the
inside of the floor brush. These lenses should
be cleaned periodically.
1. Remove floor brush from nozzle.
2. Turn floor brush upside down.
3. The two dirt sensor lenses are located on
the inside of the opening as shown. Brush
each sensor lens several times to remove dust
and dirt.
PERFORMANCE/SAFETY FEATURES
WARNING
Personal Injury Hazard
To avoid accidental brushroll starting,
always turn off and unplug the vacuum
cleaner before cleaning the brushroll area.
Failure to do so can result in personal
injury.
OVERLOAD PROTECTOR
The PowerMate
®
has built-in protection
against motor and belt damage should the
brushroll jam. If the brushroll slows down or
stops, the overload protector shuts off the
PowerMate
®
. The canister motor will continue
to run.
To correct problem: Turn off and unplug
vacuum cleaner, remove obstruction, then
press overload protector reset button.
If the problem persists, call 1-877-531-7321
Reset
Overload
Protector
ELECTRONIC SUCTION CONTROL
The electronic suction control allows you to
change the power of the vacuum cleaner
suction motor.
Increase suction
for upholsteries
and carpets.
Decrease suction
for draperies and
lightweight rugs.
Increase
Suction
SUCTION
CONTROL
Decrease
Suction
Dirt
Sensor
Dirt Sensor
Lenses
CAUTION
Never use water or any cleaning solution
when cleaning the lenses. The residue of
the water or cleaners will accelerate the
recoating of the lenses and make cleaning
necessary sooner.
- 16 -
(US) / 1-844-608-3081 (CA) for assistance.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kenmore BC7005 and is the answer not in the manual?

Kenmore BC7005 Specifications

General IconGeneral
BrandKenmore
ModelBC7005
CategoryVacuum Cleaner
LanguageEnglish

Related product manuals