Kenmore BC7005 User Manual

- 22 -
BELT CHANGING AND BRUSHROLL CLEANING
TO REMOVE BELT
1. Remove floor
brush from the
PowerMate
®
.
2. Turn PowerMate
®
upside down and
remove three (3)
screws.
3. Turn PowerMate
®
right side up.
4. Loosen the rear
latches located
below the pedals.
5. Grasp cover
by rear and pull
up to remove it
from base.
6. Unscrew two (2)
brushroll cover
screws and remove
brushroll cover.
7. Lift brushroll
assembly out
and remove
worn belt.
8. Check and clean end cap areas. See
BRUSHROLL ASSEMBLY
(page 23) for
picture of complete brushroll assembly.
Screws
ADJUST
RE
LEASE
BR
USH
RELEASE
HANDLE
B
R
U
S
H
R
E
L
E
A
S
E
H
E
I
G
H
T
A
D
J
U
S
T
HANDLE
RELEASE
Always follow all safety precautions when performing maintenance to the PowerMate
®
.
WARNING
Electrical Shock Or Personal Injury Hazard
Always turn off and unplug vacuum
cleaner before performing maintenance
to the vacuum cleaner . Failure to do so
could result in electrical shock or personal
injury from vacuum cleaner suddenly
starting.
BRUSH
REL
EASE
H
E
I
G
H
T
A
D
J
U
S
T
HANDLE
RELEASE
Brush
Release
Pedal
POWERMATE
®
CARE

Kenmore BC7005 Specifications

General

Brand	Kenmore
Model	BC7005
Category	Vacuum Cleaner
Language	English