DM-5090 (En)
42
Editing
Use the following procedure to erase desired tracks in stop
mode.
Be careful in using this operation because tracks cannot be
recovered once they have been erased.
1
To erase all MD tracks.
1 Select “Q.ERASE”.
2 Set the selection.
3 Set the selection.
To erase desired tracks.
If you want to clear all tracks in a MD, go to step 4.
Selected track
Erase desired tracks by repeating steps 1 and
2.
Reconfirmation of erasure
Title scrolling
Next track
Preparation
1 Put the MD recorder in stop mode.
2 Press the EDIT/SPACE key to switch the
editing mode on.
Erasing one or more track at a time (QUICK ERASE)
The modes are switched by rotating the JOG DIAL.
1 Q. MOVE? : Moving (reordering) tracks
2 Q.ERASE? : Erasing track(s)
Confirmation of all track erasure
Indicates erase operation.
1 Select a track number to be erased.
2 Set the selection.
Selected track
SET
JOG DIAL
4
¢
SET
JOG DIAL
4
¢
÷ Only the last selected track can be cleared by pressing the DELETE key
of the remote control unit. (To clear all of the selected tracks, cancel
editing and restart the operation from the beginning.)
÷ The orders of tracks can be confirmed by pressing the 1 key (or ¡
key) of the remote control unit.
To Next Page
Loading...
Need help?
General
