Kenwood KX-79CW User Manual

Synchro recording
Amplifier or Receiver
* Turntable (KD-58F)
(TaD) PLAY/CUT
—_/)—-
(*KD-58F)
Recording starts.
14 kx-79Cw (En)
@ Synchro recording with the turntable unit
By connecting the turntable (optional) with the system con-
trol cord, tape recording can be started in synchronism with
the start of record play.
1. Make the cassette deck ready for recording following the
procedure in the ‘‘Preparation for recording’ section.
2. Place a record on the turntable.
3. Following the procedure in the ‘‘Recording level adjust-
ment” section, play the turntable and adjust the record-
ing level.
@ When the PHONO input selector of the amplifier is
pressed, the turntable starts play automatically.
4. After adjusting the recording level, set both the cassette
deck and turntable in the stop mode.
@ if the recording level has been set based on experience,
steps 3 and 4 are not necessary.
5. Press the REC/ARM key while holding the PAUSE key (i
depressed.
6. On the turntable, press the PLAY/CUT key.
@ The turntable will start play and, at the same time, the
cassette deck will start recording.
@ To pause synchro recording temporarily:
Press the CUEING key of the turntable.
@ The cassette deck will enter the record-pause mode af-
ter reserving a non-recorded blank of about 4 seconds.
@ To resume recording press the CUEING key of the turnt-
able again.
@ To stop synchro recording:
Press the PLAY/CUT key of the turntable.
@ The turntable will stop record play, and the cassette deck
will enter the stop mode after reserving a non-recorded
blank of about 4 seconds.
* IMPORTANT:
This option may not be available in some areas. For de-
tails on options, consult your dealer.

Kenwood KX-79CW Specifications

General

Brand	Kenwood
Model	KX-79CW
Category	Tape Deck
Language	English