Kenwood TH-77A User Manual

3. BATTERY PACK
MNi-Cd BATTERY PACK(PB-10)
This battery pack has not been charged at the factory in
order to provide you with the greatest number of
charge / discharge cycles. You must charge the battery
before use. The battery pack will require several
charge / discharge cycles before you can expect to see
the maximum operating period between charges. If the
battery will be stored for longer than 2 months it
should be recharged before use.
m@ RECHARGING
CAUTION (for general market only)
The BC-12 has a voltage selection switch ( 120V /
230V). Make certain that the switch setting matches
the AC line voltage.
1. Interconnect the adapter to the NiCd battery pack.
2. Plug the battery charger into an AC outlet.
3. Do not allow the battery to charge for greater than
15 hours. The useful life and battery performance
will be reduced if you exceed the recommended
charge period:
Voltage selection switch
for general
market only
NiCd battery pack
NOTE
Recharging should be done within an ambient
temperature between 5°C ~ 40°C (41°F ~ 104°F).
Recharging performed out of this range may not
fully charge the battery.
HEMANGANESE or ALKALINE ria ab 6)
Load 6 xX R6 (AA) manganese or
alkaline batteries in series in the
optional battery case(BT-6). (Be
sure to observe the polarities.) //;
We recommend the use of high (==
perfomance manganese batteries.
Press down on the hook in the
middle of the battery case top
to open.
CAUTION
Do not install NiCd batteries and attempt to charge
them with the supplied charger. There is no battery
protection circuit in the battery holder.
MBINSTALLING THE BATTERY PACK
Align the grooves in the bat- Release button
tery pack with the transceiver I | [JA
and slide the pack to the right S&S
until it locks in place. Le
To remove the battery pack S>
push up on the RELEASE button me
and slide the pack to the left.

Kenwood TH-77A Specifications

General

Brand	Kenwood
Model	TH-77A
Category	Transceiver
Language	English