Kenwood TM-271A Service Manual

TM-271A/271E
19
Resetting the Tansceiver
If your transceiver seems to be malfunctioning, resetting
the microprocessor may solve the problem. The following 2
reset modes are available. When performing the reset, you
may lose memory data and stored information. Back up or
write down important data before performing the reset.
■ Initial Settings
The factory defaults for the operating frequencies are as
follows.
Transceiver : 144.000MHz
The Memory Channels have no data stored. The Weather
Radio frequency (AL channel) is restored as 162.550MHz (K
market model only). The Call Channel and frequency step
size default values.
Note : When in Channel Display Mode or while Key Lock is
activated, you cannot perform VFO reset or Full reset.
■ Full Reset
This resets all transceiver parameters to the factory de-
fault values. There are two methods available for resetting
the transceiver.
• Full Reset Method 1:
1. With the transceiver power OFF, press [F]+[ ] (Power).
• All indicators light momentarily, followed by the full reset
confirmation message.
■ VFO Reset
This resets the transceiver parameters excluding the
DTMF Memory, the Memory channel contents, and the Call
channel contents. There are two methods available for reset-
ting the transceiver.
Note : Menu No. 7 (P.VFO) and Menu No. 10 (OFFSET) re-
turn to the factory default values.
• VFO Reset Method 1:
1. With the transceiver power OFF, press [VFO]+[ ]
(Power).
• The VFO reset confirmation message appears.
2. Press [F].
• “SURE ?” appears.
• Press any key other than [F] to cancel.
3. Press [F] again to reset the transceiver.
• “WAIT” appears momentarily.
• Full Reset Method 2:
1. Press [F], [MENU] and turn the Tuning control to select
Menu No. 99 (RESET).
2. Press [MENU] and turn the Tuning control to select
“FULL”.
3. Press [MENU].
• “SURE ?” appears.
• Press any key other than [MENU] to cancel.
4. Press [MENU] to reset the transceiver.
• “WAIT” appears momentarily.
2. Press [VFO].
• “SURE ?” appears.
• Press any key other than [VFO] to cancel.
3. Press [VFO] again to reset the transceiver.
• “WAIT” appears momentarily.
• VFO Reset Method 2:
1. Press [F], [MENU] and turn the Tuning control to select
Menu No. 99 (RESET).
2. Press [MENU] and turn the Tuning control to select
“VFO”.
3. Press [MENU].
• “SURE ?” appears.
• Press any key other than [MENU] to cancel.
4. Press [MENU] to reset the transceiver.
RESETTING THE TRANSCEIVER

Kenwood TM-271A Specifications

General

Brand	Kenwood
Model	TM-271A
Category	Transceiver
Language	English