48
4. Reading and writing files
With ARCP-480 you can write memory channel and menu data to a file for later recall. This does
not apply in certain cases when using KNS.
●
Compatibility with KNS (Kenwood Network Command System)
KNS is the name for the system that enables remote control of the transceiver over a LAN or
WAN; ARCP-480 is equipped with the remote functions for this system. To use KNS, you need to
have at least 2 computers, the remote one having ARCP installed and the host computer having
ARHP installed.
The basic arrangement is to connect the TS-480 to a host computer, which is on a LAN, and to
install ARHP-10 on this computer. ARCP-480 is then installed on the remote computer.
RX audio & control commands TX audio & ARCP commands
To Next Page
Loading...
Need help?
General
