KERN ALS Series Operating Instruction

62 TALJG_A/TALSG_A/TPLJG_A/TPLSG_A-BA-e-2112
12.1.2 Introducing the reference weight in the numerical value
If the unit weight (reference value) is known, it can be entered directly. As when
using this method the scale need not determine the reference value, after the
reference unit weight is confirmed the scale will be switched directly to the piece
counting mode.
 Using the navigation buttons

, select the <Piece counting>
application and
confirm by pressing the PRINT button, the current setting will be displayed.
 Using the MENU button, choose the “Manual” setting.
 Confirm, pressing PRINT.
 Using the navigation buttons (see chapter 3.2.2
), enter the known reference unit
weight in grams. To set a decimal point, press the CAL
button and hold it for
some time. Pressing and holding the TARE button results in deleting the input.
 Confirm, pressing PRINT.
Starting from then, the scale is in the counting mode and counts all parts present on
the scale plate (see chapter 12.1.1 “Counting the number of pieces”).
After the minimum unit weight is exceeded, an error message is displayed. Return
to the weighing mode by pressing the ON/OFF button and restart the process.
Return to the weighing mode
 Press the ON/OFF button.

KERN ALS Series Specifications

General

Brand	KERN
Model	ALS Series
Category	Scales
Language	English