18 EMS-BA-e-1716
switch-over
Press the UNIT key in the weighing mode to switch-over
between the available weighing units
Plus/minus
weighings
For example unit weight control, fabrication control etc.
Put the nominal weight on the weighing plate and tare using
the TARE button.
Remove the nominal weight
Put the test objects subsequently on the weighing plate, the
respective deviation from the nominal weight is displayed
with the respective sign to „+“ and „-“.
According to the same procedure also packages with the
same weight can be produced, referring to a nominal
weight.
Back to weighing mode by pressing the TARE button.
To Next Page
Loading...
Need help?
General
