PNJ_PNS-SH-e-2011 - 26 -
1. Flip the board holder assy over (During this task be careful not to damage the
liquid crystal surface of the display board.)
2. Solder the tuning fork assy cable onto the AJDP circuit board.
3. Connect the cables to CN1 and CN4 on the AJDP circuit board.
4. Fix the board holder assy on the chassis in place (Insert the chassis tabs into
the notches of the board holder assy). During this task be careful not to let the
cables get caught between the notches and the tabs.
Tab
Notch
Board holder assy
To Next Page
Loading...
Need help?
General
