19
EN
3 - PRELIMINARY CHECKS
Before installing this product, verify and check the following steps:
Check that the gate or door are suitable for automation;
Check the presence and strength of the security mechanical stops
of the gate;
Check that the mounting area of the product isn't subject to
ooding;
Conditions of high acidity or salinity or proximity to heat sources
could cause malfunction of the product;
Extreme weather conditions (for example the presence of snow,
ice, high temperature range, high temperatures) may increase the
friction and therefore the force required for the handling and initial
starting point may be higher than under normal conditions;
Check that the manual operation of gate is smooth and friction-free
and there is no risk of derailment of the same;
Check that the gate is in mechanical equilibrium and stationary if
left in any position;
Ensure that all materials used for the installation comply with
current regulations;
Contact technical personnel to dismantle or repair the controller;
Keep installation site clear of ammable or explosive, or corrosive
gases and dust etc.;
Prevent foreign object or liquid approaching controller;
Don’t put metal object beside battery;
Do not touch terminals or back plate of controller in case of electric
shock or scald.
DAILY CONSUMPTION with cycles and NLS =
A+B+W+NLS= 0.535+0.02+ 1.497+0.78=2.832 A/h
DAYS with no charge with cycles and NLS =
Battery capacity / DAILY CONSUMPTION with NLS = 6 days
DAYS with no charge with no cycle only with NLS =
Battery capacity / (A+NLS) = 13 days
DAILY CONS. with cycles and no NLS, no courtesy light =
A+B+W= 0.535+0.02+1.497= 2.052A/h
DAYS with no charge with cycles and no NLS =
Battery capacity / Daily consumption with cycles and no NLS, no
courtesy light = 8.7 days
DAILY CONSUMPTION with no cycle without NLS =
Battery capacity / (0.0235 A/h x 24h) = 32 Days
To Next Page
Loading...
Need help?
General
