21
EN
12 12
STARTUP INTERFACE
BATTERY VOLTAGE
BATTERY VOLTAGE BATTERY TYPE BATTERY TYPE RECOGNITION COMMUNICATION CODE
TEMPERATURE
ERROR CODE
AH-BATTERY
DISCHARGE METER
AH-BATTERY
CHARGE METER
INPUT CURRENT OUTPUT CURRENT
SYSTEM VOLTAGE RATED CURRENT SOFTWARE VERSION
Startup interface: the interface when system is powered on by
which you check whether the LCD is in good condition
System voltage: battery voltage detected by controller.
Rated current: Rated charging and discharging current of controller
Interface one-way circulation is performed by pressing
If there’s no failure, display presents the current interface until
press any key; if there ’s failure, after 20s absence of key operation
the error code interface is presented.
In interface "Battery voltage", or "Error code" by short pressing
load is switched on or o.
5.2 - LCD Interfaces
5.3 - Battery communication
Set System voltage to 24V
In interface "Ah-Battery Charge Meter" or "Ah-Battery Discharge
Meter" by long pressing (>3S) , data is cleared.
In "Battery voltage" interface, by long pressing , and
simultaneously until the screen is fully bright controller is restored
to factory defaults.
1. LVR, ABSORB , LVD , FLOAT , P(PM)
2. Day and night
3. Battery type: FLD , GEL , SLD , Null means Usr
4. Charging
5.Error
6. Discharging
7. Time
8. Capacity
9. Load state
10. Unit
11. Data display area
12. Button
5.1 - Symbols
5 - OPERATING INSTRUCTION
ATTENTION !
To Next Page
Need help?
General
