783
Maintenance
5. Remove the bulb from the head
lamp assembly.
6. Install a new static bending light
bulb and snap the static bending
light bulb retaining wire into posi-
tion by aligning the wire with the
groove on the bulb.
7. Connect the static bending light
bulb socket-connector.
8. Install the headlamp bulb cover by
turning it clockwise.
Front fog lamp (Bulb type)
bulb replacement
1. Disconnect the negative (-) battery
terminal.
2. Disconnect the side after loosen-
ing the front bumper sides screws
and clips.
3. Disconnect the front fog lamp con-
nector.
4. Remove the socket from the
assembly by turning the socket
counterclockwise until the tabs on
the socket align with the slots on
the assembly.
5. Remove the bulb from the socket
by pressing it in and rotating it
counter-clockwise until the tabs on
the bulb align with the slots in the
socket. Pull the bulb out of the
socket.
6. Insert a new bulb by inserting it
into the socket and rotating it until
it locks into place.
7. Install the socket in the assembly
by aligning the tabs on the socket
with the slots in the assembly.
Push the socket into the assembly
and turn the socket clockwise.
8. Connect the front fog lamp con-
nector.
9. Install the front bumper side
assembly to the body of the vehi-
cle.
OYB070152L
To Next Page
Loading...
Need help?
General
