Battery Installation/Replacement (continued)
Battery Replacement/Installation Instructions
To install or replace the batteries in your Kidde unit please per-
form the following steps:
1. Gently flip open
the lower half of
the front cover to
expose the battery
compartment.
2. Remove the old
batteries and properly
dispose of them as
recommended by the
battery manufacturer
(see figure 10).
3. Reinstall the new batteries, being careful to seat
the red battery warning flags in the recess of the
battery well. Also, note the polarity illustration in
the bottom of the battery compartment. If applicable, the
unit will chirp and display for approximately one
minute and return to normal operation.
4. Gently close the bottom cover. The bottom cover of
your CO alarm will NOT close if all three AA
batteries are not properly installed.
To Next Page
Loading...
Need help?
General
