Installation Instructions
Mounting
1. Using the template provided (see
page 25). Mark the location on wall.
2. Insert the two screws provided until
the screw heads are approximately
1/8” from wall. (If mounting in
plaster board or drywall, drill 3/16”
hole and use the plastic anchors
provided.)
3. Hook the Kidde CO Alarm unit over the screws onto keyholes in back
of unit.
The digital model may also be placed on a tabletop. Simply fold out the
stand located on the back of the unit and place in a location that is easily
visible.
Two self adhesive labels are included with the CO alarm. Add the phone
number of your emergency service provider in the space provided. Place
one label next to the alarm and one label near a fresh air source such as a
door or window.
Where To Install Your Kidde CO Alarm
The following suggestions are intended to help you with the
placement and installation of your Kidde CO Alarm.
•
When wall mounting, place out of the reach of children.
Under no circumstance should children be allowed to
handle the CO alarm.
•
Install in a sleeping area.
•
Placing at eye level allows for optimum monitoring of
the digital display.
•
Insure that all vents of the unit are unobstructed.
•
For tabletop mounting we recommend the unit be
placed no higher than three feet from the floor.
WARNING: The installation of this device should not be used as a sub-
stitute for proper installation, use, and maintenance of fuel-burning
appliances, including appropriate ventilation and exhaust systems.
Figure 1
8
To Next Page
Loading...
Need help?
General
