21
OPERATING INSTRUCTIONS
Pruning
Pruning is trimming limbs from a live tree.
• Work slowly, keeping both hands on the chain saw
with a rm grip. Always make sure your footing is
secure and your weight is distributed evenly on both
feet.
• Do not cut from a ladder. This is extremely dangerous.
Leave this operation for professionals.
• Do not cut above chest height as a saw held higher is
difcult to control against kickback.
• When pruning trees it is important not to make the
nishing cut next to the main limb or trunk until you
have cut off the limb further out to reduce the weight.
This prevents stripping the bark from the main
member.
• Underbuck the branch 1/3 through for your rst cut.
• Your second cut should overbuck to drop the branch
off.
• Now make your nishing cut smoothly and neatly
against the main member so the bark will grow back to
seal the wound.
If the limbs to be pruned are above chest height, hire a professional to perform the pruning.
WARNING
When bucking on a slope always stand on the uphill side
of the log. When cutting through to maintain
complete
control, release the cutting pressure near the end of the cut
without relaxing your grip on the chain saw handle. Don’t let
the chain contact the ground. After completing the cut, wait
for the saw chain to stop before you move the chain saw.
Always stop the motor before moving from tree to tree.
Bucking a log
Stand on uphill side when cutting
because log may roll
Second Cut
First Cut
1/3 Diameter
Finishing Cut
LOAD
To Next Page
Loading...
Need help?
General
