kobalttools.com
23
CARE AND MAINTENANCE
• When servicing, use only identical replacement parts. Use of any other parts may create a hazard
or cause product damage.
• Always wear safety goggles or safety glasses with side shields during power tool operation or
when blowing dust. If the operation is dusty, also wear a dust mask.
General maintenance
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from
various types of commercial solvents and may be damaged by their use. Use clean cloths to remove
dirt, dust, lubricant, grease, etc.
•
come in contact with plastic parts. Chemicals can damage, weaken, or destroy plastic, which may
result in serious personal injury.
Lubrication
of the unit under normal operating conditions. Therefore, no further lubrication is required for the
bearings.
Replacing the guide bar and chain
WARNING
DANGER
Never start the motor before installing the guide bar, chain, chain cover, and chain cover lock knob.
injury.
WARNING
• To avoid serious personal injury, read and understand all the safety instructions in this section.
• Before performing any maintenance, make sure the battery is removed. Failure to heed this
warning could result in serious personal injury.
CAUTION
Always wear gloves when handling the bar and chain; these components are sharp and may contain
burrs.
WARNING
Never touch or adjust the chain while the motor is running. The saw chain is very sharp; always wear
protective gloves when performing maintenance to the chain to avoid possible serious lacerations.
Note:
bar and chain combinations section later in this manual.
To Next Page
Loading...
Need help?
General
