35
BEFORE USING THE TILE SAW
WARNING: To avoid mistakes that could cause serious, permanent injury, do not plug the tool
in until the following steps are completed:
● Completely assemble and adjust the tile saw, following the instructions (SEE ASSEMBLY AND
ADJUSTMENTS SECTIONS).
● Review the entire manual and understand all safety instructions and operating procedures in
this Instruction Manual (SEE IMPORTANT SAFETY & OPERATIONS SECTIONS).
● To avoid injury or possible death from electrical shock, make sure your ngers do not touch
the plug’s metal prongs when plugging or unplugging your tile saw (SEE ELECTRICAL
REQUIREMENTS AND IMPORTANT SAFETY SECTIONS).
BASIC SAW OPERATIONS
● Overlling the water tray can lead to water entering the motor compartment and potential
electric shock.
● When lling/draining water tray, make sure wet tile saw is unplugged from wall outlet.
OPERATING INSTRUCTIONS
LED LIGHT ON/OFF SWITCH (FIG. 36)
Turn the LED light on and o by pressing the
LED light ON/OFF switch (VV) located on the
side of the motor handle.
NOTE: The saw must be plugged in for the LED
light to operate.
ON/OFF SWITCH (FIG. 36)
The ON/OFF switch has a removable safety
key (Dd). With the key removed from the switch,
unauthorized and hazardous use by children and
others is minimized and the saw will not turn on.
● To turn the saw “ON”, insert the safety
key (Dd) into the slot of the ON/OFF
switch (HH), and move the switch upward to
the “ON” position.
● To turn the saw “OFF”, move the ON/OFF
switch (HH) downward.
● To lock the switch in the OFF position, grasp
the sides of the safety key (Dd), and pull it
out.
● With the switch key removed, the switch will
not operate to power the saw on.
WARNING: ALWAYS lock the switch “OFF”
when the tile saw is not in use. Remove the
key and keep it in a safe place. In the event
of a power failure, blown fuse, or tripped
circuit breaker, turn the switch “OFF” and
remove the key, preventing an accidental
startup when power comes on.
WARNING
36
Dd
VV
HH
To Next Page
Loading...
Need help?
General