kobalttools.com
5
SAFETY INFORMATION
•
• Keep proper footing at all times. Do not overreach, as slipping, tripping, and/or falling can be
a major cause of serious injury and/or death. Be aware of excess hose left in working area or
work surface.
• DO NOT abuse hoses or connectors.
• When using tools, always carry the tool by the handle. Never carry the tool by the hose or yank
it to disconnect it from the air or power supply.
• Keep hoses away from heat, oil, and sharp edges. Check hoses for weak or worn connections
before each use and make sure that all connections are secure before use.
• DO NOT use pressure exceeding the operation pressure of any of the parts (hoses,
• NEVER
can result in serious injury or death.
• ALWAYS disconnect tool from air supply before performing any maintenance.
• NEVER use a tool which is leaking air, has missing or damaged parts, or requires repair.
• Only use parts and accessories recommended by the manufacturer.
• NEVER exceed the maximum pressure recommended by the manufacturer.
WARNING
SOME DUST CREATED BY PAINT SPRAYING, POWER SANDING, SAWING, GRINDING,
DRILLING, AND OTHER RELATED ACTIVITIES IS KNOWN TO THE STATE OF CALIFORNIA
TO CAUSE CANCER, BIRTH DEFECTS, AND OTHER REPRODUCTIVE HARM. A LISTING OF
CHEMICALS CAN BE OBTAINED FROM www.oehha.ca.gov UNDER PROPOSITION 65. SOME
EXAMPLES OF THESE CHEMICALS ARE:
• LEAD FROM LEAD BASED PAINTS
• CRYSTALLINE SILICA FROM BRICKS, CEMENT AND OTHER MASONRY PRODUCTS
• ARSENIC AND CHROMIUM FROM CHEMICALLY TREATED LUMBER
YOUR RISK FROM THESE EXPOSURES VARIES, DEPENDING ON HOW OFTEN YOU DO
THIS TYPE OF WORK. TO REDUCE YOUR EXPOSURE TO THESE CHEMICALS, WORK IN A
WELL VENTILATED AREA AND WORK WITH APPROVED SAFETY EQUIPMENT, SUCH AS
SUCH AS A RESPIRATOR OR DUST MASKS WHICH ARE SPECIALLY DESIGNED TO FILTER
MICROSCOPIC PARTICLES.
PREPARATION
Before beginning operation of this product make sure all parts are present. Compare parts with
package contents list. If any components are missing, please contact 1-888-356-2258. Do not
use the item if parts are missing.
Estimated Assembly Time: 5-10 minutes
Make sure the specific type of flooring and the specific fastener which you have chosen are
compatible. Make sure that when using the flooring nailer that you avoid pipes and/or any type of
cables below your subfloor. If you have any questions regarding which type of fastener or which
sized base place should be used with your specific flooring application, please contact your
nearest retailer for further assistance. This flooring nailer is designed to work with three different
floor thicknesses: 1/2 inch, 5/8 inch, and 3/4 inch.
To Next Page
Loading...
Need help?
General
