Kodak Carousel 860H User Manual

f
SLIDE TRAY
Furnished with your new projector is the KODAK CAROUSEL
140 Slide Tray. It holds 140 slides in 2 x 2·inch cardboard
or
thin plastic mounts (not glass or metal mounts) up to k'6
inch thick. Since this tray was designed to hold as many
slides
as possible, the slide compartments in the tray are
quite narrow. For
this reason, your slide mounts should be
in good condition. Mounts that are warped or bent may
fail to drop from the tray into the projector.
(If this hap·
pens, straighten the mount with your fingers or place the
slide
in a new mount, such as a KODAK READy·MoUNT.)
Clip off all mount corners that are frayed. Do not
attempt to project slides mounted with loose or sticky tape.
As the tray revolves, the number of the slide being pro·
jected will
be opposite the gate index on the projector.
(Additional slide trays can be obtained from your dealer;
see page 17.)
LOADING SLIDE TRAY
Check the bottom of the tray to make sure the INDE X HOLE
is opposite the INDEX NOTCH. If it isn't, slide the LATCH in
the direction shown by the arrow, and turn the bottom
plate until the index hole points to the index notch. Then
release the latch.
Remove the
LOCK RING from the tray by turning the ring
in the direction of the arrow marked UNLOCK; then lift
off the ring. Insert a slide into ea ch slot in the tray, with
the top of the picture down . The printed border or trade·
mark side of each cardboard·mounted slide-or emulsion
(dull) surface
of a slide mounted in plastic-should face
the next lower number. For example, the bordered trade·
mark (or emulsion) side of slide
No .2 should face toward
slide
No . 1, No . 3 toward No . 2, etc.
Replace the lock ring,
turning it in the direction of the
arrow marked
LOCK until the ring is secure on the tray.
LOCK RING

Kodak Carousel 860H Specifications

General

Brand	Kodak
Model	Carousel 860H
Category	Projector
Language	English