46 www.kodak.com/go/support
Troubleshooting
Direct printing (PictBridge) problems
Ready light glows
steady green
■ Shutter button is pressed halfway down. Focus and exposure are set.
Camera is operating normally.
Ready light glows
steady orange
■ The Mode dial is set to Favorites. Camera is operating normally.
Ready light blinks
orange
■ Flash is not charged. Wait. Resume picture-taking when the light stops
blinking and turns off.
■ Auto exposure or auto-focus are not set. Release the Shutter button
and recompose the picture.
Ready light glows
steady red
■ Camera’s internal memory or card is full. Transfer pictures to the
computer (page 16), delete pictures from camera (page 13), switch
image storage locations (page 31), or insert card with available
memory (page 3).
■ Camera processing memory is full. Wait. Resume picture-taking when
the light turns off.
■ Card is read-only. Change image storage location to internal memory
(page 31), or use a different card.
Status Solution
Cannot locate desired picture.
■ Turn the Mode dial to Auto. Make sure the camera is
not in Favorites mode.
■ Use the Direct print menu to change the image storage
location.
The Direct print menu interface
turns off.
■ Press any button to redisplay the menu.
Cannot print pictures.
■ Ensure that there is a connection between camera and
printer (page 17).
■ Ensure the printer and camera have power (page 18).
Camera or printer display an
error message.
■ Follow the prompts to resolve the issue.
To Next Page
Loading...
Need help?
General
