17
STARTING THE ENGINE
Prior to starting the engine the following must be performed.
1. Check engine oil level.
2. Check for fuel leaks.
3. Run bilge blower for a minimum of 10 minutes.
4. Check Coolant level.
5. Check bilge for excess water before starting engine.
WARNING: The bilge can accumulate explosive fumes. The bilge
blower will evacuate the fumes. The bilge blower must be run for a minimum
of 10 minutes prior to cranking the engine.
WARNING: Do not start or run the engine in a closed or poorly
ventilated area where exhaust gases may accumulate. All internal
combustion engines give off various fumes and gases while running. Avoid
breathing these gases as they may contain poisonous carbon monoxide and
other gases, which can endanger your health or life if inhaled steadily for a
few minutes.
CAUTION: The bilge should be checked for excess water prior to
starting the engine. Excess water can cause premature starter failure and
damage to other engine components.
NOTE: This engine is equipped with a computer controlled starter circuit. It
is not necessary to hold the ignition switch in start mode until the engine
starts, although holding the key on will not cause any issues.
CAUTION: If the engine stalls or falters during starting, wait 3 to 4
seconds before re-engaging the starter. This will prevent possible damage to
the starter or the engine. Do NOT operate the starter for periods longer than
5-8 seconds at a time. An interval of at least 1 minute should be observed
between cranking periods to protect the starter from overheating.
To Next Page
Loading...
Need help?
General
